Triumph TR6 PI Operation Manual page 324

Refitting
15. Locate the steering column in position in the car.
16. Offer up the steering lock/ignition switch to the
steering column. Ensure that the spacer ring is above
the steering lock/ignition switch.
17. Fit the steering lock/ignition switch clamp and secure
the two new shearbolts.
18. Evenly tighten the shearbolts until the heads shear.
19. Ensuring that the front road wheels are in 'straight
ahead' position and the steering wheel is centralised,
engage the lower steering mast in the flexible
coupling. Check that the steel tubular spacer, bullet
and plastic washer are fitted to the lower mast.
20. Fit the pinchbolt to the lower column and flexible
coupling.
21. Fit the harness cover to the steering column.
22. Engage the anti-torque strap on the underside of the
column upper bracket. Fit the felt strip to the lower
half of the
~,'racket.
23. Fit the spring clip and the upper half of the steering
coltlmn bracket and secure with two bolts, plain
washers and nuts. Note that the left hand bolt is
entered from below the bracket; The right hand bolt
is entered from above the bracket. Fit the domed
protective covers over the two nuts.
24. Align the slot in the upper mast with the flat on the
lower mast. Slide the plastic washer upwards until it
is in contact with the steering column housing.
25. Fit the· safety clamp between the bullet and the
plastic washer and secure with two bolts.
26. Connect the wiring sockets for lights, flashers and
starter/ignition etc.
Triumph TR6 Manual. Pact No. 545277 Issue I
STEERING
27. Fit and tighten the two bolts, washers and nuts
securing the front of the anti-torque strap to the
scuttle.
28. Fit the speedometer and tachometer to the facia. See
88.30.01 and 88.30.21.
NT.251.2
Sheet 3 57.40.01