Table of Contents
Advertisement
FRONT SUSPENSION
Refitting
10.
Using a 90 S.A.E. EP lubricant partially fill (25%) the
trunnion. Fit the rubber boot and screw the trunnion
into position on the vertical link. (Right hand vertical
link - right hand thread: Left hand vertical link -
left hand thread).
11.
Fit the vertical link washers- and trunnion to the
lower wishbone.
12.
Reverse instructions I to 7. The slotted nut should be
tightened to a torque of 50 to 65 Ibfft (4'8 to 9 kgf
m).
Removing
I.
Jack up the car and support the chassis.
2.
Remove the road wheel.
3.
Remove the front hub
60.25.01/02.
4.
Remove the disc shield. 70.10.18.
5.
Locate a jack under the road spring pad on the lower
wishbone and raise the jack sufficient to relieve the
upper ball joint and trunnion of spring tension.
6.
Remove the split pin from the slotted nut securing
the trunnion to the lower wishbone.
7.
Remove the slotted nut and bolt securing the
trunnion to the lower wishbone.
8.
Withdraw the trunnion washers and the vertical link
from the lower wishbone.
9.
Unscrew the trunnion from the vertical link .(Right
hand vertical link
~
right hand thread: Left hand
vertical link - left hand thread.)
TRUNNION
- Remove and refit
60.15.03
60.15.03
Triumph TR6 Manual. Part No. 545277 Issue 1
Hide quick links:
Advertisement
Table of Contents
