Triumph TR6 PI Operation Manual page 498

45. Adjust pinion movement as follows:
Provide a six volt test circuit as shown. Slacken the
locknut. Screw the eccentric pin fully in. Energise the
circuit to cause the solenoid to move the starter drive
to the engage position. Position a feeler gauge
between the pinion and the thrust collar as shown.
Press the pinion lightly towards the motor to take up
any lost motion in the linkage. Rotate the eccentric
pin within the indicated 180 degree arc to adjust the
gap to 0'005 to 0·015 in. Tighten the locknut. Check
that the correct gap has been maintained.
ELECTRICAL
I
I
-"
O'005-0'015IN.~~
O·13-0·38MM.
41 43
42
L439D
Triumph TR6 Manual. Part No. 545277 Issue J
86.60.13 Sheet 4