Triumph TR6 PI Operation Manual page 516

Removing
I. Perform 86.65.17 operations 1 to 5.
2. Disconnect two snap connectors.
3. Remove two screws. Withdraw two escutcheons.
4. Unscrew the bezel. Remove the switch with its
harness.
SWITCHES
- Overdrive manual switch
- remove and refit
Overdrive vehicles only.
86.65.35
ELECTRICAL
Refitting
5. Thread the switch harness through the appropriate
steering column apertures, fascia panel aperture and
steering column clamp aperture. Do not disturb the
position of the felt strip located below the wires in
the lower half of the steering column clamp. This
operation may be facilitated by taping the er-ds of the
wires together. Positton the switch and secure with
the bezel.
6. Position two escutcheons. Secure with two screws.
7. Ensure that the felt strip is correctly located and
rectify if necessary.
8. Connect two snap connectors as follows:
Yellow/green switch wire to yellow/green main
harness wire.
Black switch wire to yellow main harness wire.
9. Perform 86.65.17 operations 14 to 18.
Triumph TR6 Manual. Part No. 545277 Issue 1 86.65.35