Triumph TR6 PI Operation Manual page 344

FRONT SUSPENSION
I. Jack up the car and remove the front wheel.
2. Remove the disc brake pads.
3. Check the front hub for bearing end-float. End-float
should be within 0003 to 0005 in (0"08 to 0'13
rom).
Refitting
3. Partially pack the hub with cle~ grease.
4. Lubricate the new hub seal and enter the seal in the
hub.
5. Fit the hub tothe stub axle 60.25.01/02.
Adjustinl
4. Wire wheels only.
Remove the hub extension.
5. Remove the hub cap.
6. Remove the split pin from the slotted nut.
7. Tighten or slacken the slotted nut as necessary to
obtain 0003 to 0005 in (0"08 to 0·13 rom) bearing
end-float.
8. Secure the slotted nut with a new split pin.
9. Clean
th~
hub cap and partially fill it with fresh
grease.
10. Fit the hub cap.
11. Wire
wheels only.
Fit the hub extension.
12. Fit the brake pads.
13. Fit the road wheel and remove the jack.
60.25.15
60.25.13
60.25.14
- Remove and refit
FRONT HUB OIL SEAL
Removing
1. Remove theJront hub 60.25.01/02.
2. Withdraw the oil seal.
As operation 60.25.07/08.
FRONT HUB BEARINGS
- Remove and refit
FRONT HUB BEARING END-FLOAT
- Check
and adjust
Checking
Triumph TR6 Manual. Part No. S4S277Issue 1
60.25.13
60.25.15