Table of Contents
Advertisement
ELECTRICAL
SWITCHES
- Seat belt - gearbox switch -
remove and refit
Later U.S.A. market vehicles only.
86.65.28
Removing
1.
Remove the gearbox tunnel cover 76.25.07.
2.
Locate the required switch.
3.
Disconnect two Lucar connectors.
4.
Using a spanner on the hexagon. unscrew the switch.
5.
Collect up the fibre washer/washers if fitted.
Refitting
6.
Assemble with the same number of fibre washers as
originally fitted. Use new fibre washer/washers if
available.
7.
Fit the switch and fibre washer/washers to the
gearbox.
8.
Connect two
~ucar
connectors. The connectors may
be fitted either way round.
9.
Perform a functional check of the seat belt warning
circuit.
10.
Refit the gearbox tunnel cover 76.25.07.
SWITCHES
Removing
I.
Remove
the
passengers seat from the vehicle
76.70.05.
2.
Unhook two rear diaphragm attachment clips.
3.
Unhook two side diaphragm attachment clips.
4.
Bend four smail clips upwards and remove two
washers.
5.
To assist refitting, note the wire run through the seat.
6.
Withdraw the wires.
7.
Remove the switch.
- Seat belt - passengers seat switch -
remove and refit
Later U.S.A. market vehicles only.
86.65.29
NTO 717
Refitting
8.
Reverse instructions I to 7.
86.65.28
86.65.29
Triumph TR6 Manual. Part No. 545277 Issue I
Hide quick links:
Advertisement
Table of Contents
