Triumph TR6 PI Operation Manual page 224

CLUTCH
Refitting
6. Slide the release bearing assembly into position on
the gearbox front end cover.
7. Fit the tapered coil anti-rattle spring to the
withdrawal shaft (narrow end of taper adjacent to the
drop arm).
8. Rotate the release beanng assembly to position the
anti-rotation pin centrally above the gearbox primary
shaft (12 o'clock position).
9. Engage the withdrawal fork in the release bearing
assembly ensuring that the machined flats on the fork
ends are located on the engine side of the withdrawal
shaft.
10** Slide the withdrawal shaft through the bushes and the
withdrawalfork.**
II. Align the screwed boss of the withdrawal shaft and fit
and tighten the square-headed pinchbolt.
12. Secure the pinchbolt with locking wire.
13. Fit the gearbox to the car 37.20.0 l.
NOTE: that the slave cylinder push rod should engage the
centre hole in the withdrawal shaft drop arm.
- Remove and refit
Removing
\
\
0\
NT 2 685
/~.'
r '
~
c
~
~O'"
/10/ , , \
'///0/ \ 0\
/
0/
33.25.12
Remove the gearbox 37.20.01.
Withdraw the release bearing assembly from the
gearbox front end cover.
Remove the locking wire from the square-headed
pinch pin securing the withdrawal link to the
withdrawal shaft.
Remove the pinch pin.
Remove the withdrawal shaft, anti-rattle spring and
the withdrawal fork.
I.
4.
5.
3.
CLUTCH WITHDRAWAL MECHANISM
3. Reverse instructions I and 2.
Refitting
Removing
1. Release the spring hook from the pedal box.
2. Release the spring hook from the clutch pedal.
/
:\~'.
-~
~
u
/
~
33.30.03
33.30.02
Refer 70.35.01
- Remove and refit
- Remove and refit
CLUTCH PEDAL
CLUTCH PEDAL RETURN SPRING
NT2606
33.25.12
33.30.02/03
Triumph TR6 Manual. Part No. 545277 Issue 2
~
~