Triumph TR6 PI Operation Manual page 111

Refitting
4. Wash the strainer gauze in petrol and allow to dry.
5. Screw the strainer into the pump cover plate until the
measurement A between the pump body face and the
end of the strainer gauze is 4'25 in
(i~).
toa--
6. Tighten the locknut to 20
~
24 Ibf ft (2'S - 3'3 kgf
m).
7. Refit the sump 12.60.44.
ENGINE
!
I
NT2 503
A
----------1
Removing
1. Isolate the battery.
2. Drain the oil sump.
3. Remove the sump 12.60.44.
4. Slacken the three bolts retaining the pump to the
crankcase and whilst holding the pump cover i1).
position slacken the bolts completely and remove the
pump.
NOTE: If the pump is not to receive attention use 'slave'
nuts on the bolts to keep the pump cover in positio"n
to prevent the ingress of foreign matter.
OIL PUMP
-
Remov~
and refit 12.60.26
...
-C'-=--~.-
0_)
~-='
J
~
fell
~~j-'\\~/~
\t::.J;_1
,II,
4
NT2501
Refitting
5. Clean the crankcase and oil pump mating faces and
offer up the pump to the crankcase ensuring that the
oil pump spindle engages positively into the
distributor drive gear shaft before evenly tightening
the bolts and spring washers to 7 - 9 Ibf ft (I '0 - 1 '2
kgf m).
6. Reverse instructions I to 3.
~.~L'·A'·NHD
~
Triumph TR6 Manual. Part No. 545277 Issue I
12.60.20 Sheet 2
12.60.26