Triumph TR6 PI Operation Manual page 369

Refitting
5. Fit new sealing rings.
6. Fit the reservoir to the master cylinder and evenly
tighten the four securing screws.
Removing
I. Remove the master cylinder 70.30.08.
2. Drain the reservoir and master cylinder.
3. Remove the four screws (underside of reservoir)
securing the reservoir to the master cylinder.
4. Lift off the reservoir and remove the two sealing
rings.
Refitting
10. Reverse instructions I to 9.
Removing
I. Remove the two nuts, spring washers and bolts
securing the accelerator pedal bracket to the pedal
box.
2. Release the accelerator pedal return spring.
3. Remove the spring clip and release the accelerator
cable from the accelerator pedal.
4. Withdraw the accelerator pedal.
5. Disconnect the two spade terminals from the brake
stop switch.
6. Remove the four nuts and plain washers securing the
servo to the pedal box.
7. Remove the four bolts and spring washers securing
the clutch master cylinder bracket to the scuttle.
8. Remove the seven bolts, plain washers and spring
washers securing the pedal box to the scuttle.
9. Withdraw the pedal box assembly.
FLUID RESERVOIR
- Remove and refit
PEDAL ASSEMBLY
- Remove and refit
70.30.15
70.35.01
BRAKES
•
L ZJ
Triumph TR6 Manual. Part No. 5452'-7 Issue 1
70.30.15
70.35.01