Triumph TR6 PI Operation Manual page 353

REAR SUSPENSION
REAR HUB BEARINGS
Continued
3
2
64.15.14 - Remove and refit
Service Tools S317, S318, M86C, S4221 A and S4221 A-16
Removing
I. Remove the rear hub and drive shaft assembly.
64.15.01.
2. Mount the hub and drive shaft assembly on tool
S318.
3. Remove the nyloc nut and plain washer securing the
hub to the stub shaft.
**
NOTE: On later models a castellated nut and split pin
is fitted.
**
4. Using tool M86C withdraw the hub complete with
the outer bearing.
5. Remove the key from the stub shaft.
6. Withdraw the bearing housing.
7. Remove the collapsible spacer, inner bearing and
distance piece-and stoneguard from the ttub shaft.
8. Straighten the locking tabs securing the bearing
adjusting nuts and remove adjusting nut, tab washer
and locRnut.
9. Remove the inner and outer oil seals from the bearing
housing.
10. Remove the inner and outer bearing
trac~s
from the
bearing housing. Bearing outer tracks should not be
disturbed unless renewal is intended.
11. Remove the outer bearing (Tool S422 I A and adaptor
(6).
12.. Thoroughly clean all components.
Triumph TR6 Manual. Part No. 545277 Issue 2
64.15.14 Sheet 1