Triumph TR6 PI Operation Manual page 103

II. Working under the car, remove the L.H. nut and
spring washer from the bolt securing the rubber
mounting to the overdrive. Leave the bolt in position.
12. Remove the mounting from the chassis.
Refitting
13.- Clean the overdrive and the mounting mating faces
and offer-up the mounting to the securing bolts. Fit
and loosely tighten the L.H. nut and spring washer.
14. Fit the exhaust pipe hanger bracket with the captive
nut to the R.H. side and secure with the bolt and
spring washer.
IS. Finally tighten the L.H. and R.H. bolts evenly.
16. Place the chassis plate in position with the
narrowest width towards the rear of the car and
attach it to the chassis brackets with the four bolts,
but do not fit the nuts at this stage.
17. Lower the overdrive unit so that the mounting studs
pass through the two elongated holes. To achieve this,
movement of the mounting plate is possible within
the limits of the four elongated holes.
18. Secure the chassis plate to the chassis brackets
with the four nuts, bolts, spring and plain washers.
19. Fit and tighten the two nuts with plain and spring
washers to the mounting studs.
20. Reverse instructions I to 6.
continued
16
Triumph TR6 Manual.
Pan No. 545277 Issue 1
ENGINE
12.45.08 Sheet 2