Triumph TR6 PI Operation Manual page 144

FUEL SYSTEM PI
COLD START CABLE
- Remove and refit 19.20.26
Removing
I . Disconnect the inner cable from the metering
distributor excess fuel lever.
2. Disconnect the inner cable from the cold start cam on
the throttle linkage and release the spring.
3. Unscrew the locknut behind the control panel and
withdraw the cable complete through the control
panel, locknut and bulkhead.
Refitting
4. Feed the cable complete through the control panel
hole and pass the locknut over the cables.
5. Secure the outer cable to the control panel with the
locknut so that the end of the threaded part of the
outer cable
is
flush with the plated ferrule on the
control panel.
6. Feed the engine end of the cable through the
bulkhead.
7. Connect the inner cable to the metering distributor
excess fuel lever and ensure that there is sufficient
slack in the cable to allow the lever to rest against its
stop when the control knob is pushed fully home.
8. Connect the inner cable to the cam on the throttle
linkage and adjust the cable by means of the adjuster.
Ensure that there is clearance between the cam and
adjusting screw.
NT2389
19.20.26 P.I.
Triumph TR6 Manual. Part No. 545271 Issue I