Table of Contents
Advertisement
FUEL SYSTEM PI
THROTILE LINKAGE - P.I.
**(Up to Engine No. CP 77609E)**
- Remove and refit
19.20.07
Removing
1.
Remove the air intake manifold 19.70.01
2.
Disconnect the throttle cable and the return spring
from the linkage 19.20.06.
3.
Disconnect the cold start control cable and return
spring 19.20.26.
4.
Remove the spring clips from three vertical links.
5.
Remove the six bolts complete with washers securing
the linkage to the induction manifold.
Q.
Remove the linkage complete from the engine.
Refitting
7.
Offer-up the linkage to the manifold passing each of
the three vertical links through the throttle spindle
trunnions. Secure the linkage by the centre throttle
bracket only using two bolts, plain and spring
washers.
8.
Loosely secure the two endbrackets to the manifold
so that the brackets may be moved laterally within
the limits of the elongated holes.
9.
Adjust the countershaft by means of the elongated
holes in the two end brackets so that no end·float
exists in the shaft. Ensure, however that the vertical
links are at right angles to the countershaft. Tighten
the four securing bolts.
10.
Check and if necessary adjust the position of the cold
start cam in relation to its adjusting screw, ensuring
that the cam is central on the screw head.
11.
Fit the spring clips to the trunnion end of the vertical
links.
12.
Reconnect the throttle cable and spring.
13.
Reconnect the cold start cable and spring.
14.
Adjust the linkage 19.20.05.
15.
Refit the air intake manifold 19.70.01.
19.20.07 P.I. Sheet 1
Triumph TR6 Manual. Part No. 545277 Issue 2
Hide quick links:
Advertisement
Table of Contents
