Triumph TR6 PI Operation Manual page 106

STEERING
ENGINE REAR GEARBOX ADAPTOR PLATE
- Remove and refit 12.53.03
Removing
1. Remove the starter motor 86.60.01.
2. Remove the flywheel 12.53,07.
3. Remove the seven bolts and spring washers securing
the adaptor plate to the cylinder block.
4. Remove the plate carefully easing
it
off the two
locating dowels.
Refitting
5. Clean the cylinder block and adaptor mating faces
and fit the plate to the cylinder block ensuring that it
locates squarely over the two dowels.
6. Secure the plate to the cylinder block with the seven
bolts and spring washers.
7. Refit the flywheel - instructions 7 to 14, 12.53.07.
8. Refit the starter motor 86.60.01.
J
o
L
Continued
Removing
1. Remove the gearbox assembly from the car 37.20.01.
2. Remove the clutch from the flywheel - instructions
2 and 3, 33.10.01
3. Remove the four bolts securing the flywheel to the
crankshaft.
4. Lift off the flywheel.
5. Remove the spigot bush from the back of tte
flywheel- instruction 2,12.21.45.
FLYWHEEL
- Remove and refit 12.53.07
NTO 476
12.53.03
12.53.07 Sheet I
(I ~L'T'.H
Triumph TR6 Manual. Part No. 545277 Issue 2
~
LAYLAND