Triumph TR6 PI Operation Manual page 520

Removing
1. Perform 86.65.17 operations 1 to 5.
2.' Disconnect three snap connectors.
3. Remove two screws. Withdraw two escutcheons.
4. Remove two screws and anti-vibration washers
Remove the switch with its harness.
SWITCHES
- Turn signal switch - remove and refit
2-8~
NTQ887
86.65.54
ELECTRICAL
Refitting
5. Thread the switch harness through the appropriate
steering column apertures, fascia panel aperture and
steering column clamp aperture. Do not disturb the
position of the felt strip located below the wire in the
lower half of the steering column clamp. This
operation may be facilitated by taping the ends of the
wires together. Position the switch and secure with
two screws and anti-vibration washers.
6. Position two escutcheons. Secure with two screws.
7. Ensure that the felt strip is correctly located and
rectify if necessary.
8. Connect three snap connectors as follows:
Light green/brown switch wire to light green/brown
main harness wire.
Green/red switch wire to green/red main harness wire.
Green/white switch wire to green/white main harness
wire.
9. Perform 86.65.17 operations 14 to 18.
~~
3-6
Triumph TR6 Manual. Part No. 545277 Issue I
86.65.54