Triumph TR6 PI Operation Manual page 480

RELAYS
- Hazard relay - remove and refit 86.55.02
ELECTRICAL
Early left han4 steer vehicles with hazard circuit using relay.
Removing
I. Lift the bonnet and locate the hazard relay on the
left hand front wheelarch closin,: r>anel. The' hazard
relay is identified by being connected to the wires
listed in operation 4.
2.
~connect
five Lucar connectors.
3. Remove two nuts, spring washers, washers and
screws. Lift the relay from the vehicle.
Refitting
4. Reverse instructions I to 3. Connect the Lucar
connectors as follows:
Purple/red wire to terminal WI
Black wire to terminal W2
Green/white
wi{~
to terminal CI
Light green/pink wire to terminal C2
Green/red wire to terminal C4
RELAYS
---{Jr-----------
Refitting
4. Reverse instructions I to 3. Connect the Lucar
connectors as follows:
White wire to terminal WI
Yellow/green wire to terminal W2
Brown wire to terminal CI
Yellow/purple wire to terminal C2
Removing
I. Lift the bonnet and locate the overdrive relay on the
left hand front wheelarch closing panel. The overdrive
relay is identified by being connected to the wires
listed in operation 4.
2. Disconnect four Lucar cor-nectors.
3. Remove two nuts, spring washers, washers and
screws. Lift the relay from the vehicle.
Overdrive relay - remove and refit
Overdrive vehicles only.
86.55.04
Triumph TR6 Manual. Part No. 545277 Issue 1
86.55.02
86.55.04