Triumph TR6 PI Operation Manual page 346

FRONT SUSPENSION
Removing
1. Jack up the car and remove the front wheel.
2. Wire wheels only. Remove the four nuts securing the
hub extension to the hub and withdraw the hub
extension.
3. Tap the wheel stud(s) towards the brake disc.
4. Withdraw the stud(s). Wheel stud removal is not
advised unless renewal is intended.
Refitting
5. Ensure that the mating tapered faces of stud and hub
flange are clean.
6. Enter the stud from the brake disc side of the hub.
7. Using suitable packing (e.g. a short length of steel
tubing) draw the stud into position with the wheel
nut or hub extension nut.
8. Remove the nut and packing.
9. Fit the road wheel (hub extension and road wheel -
wire wheel models only) and remove the jack.
NT2516
I
I
l',-L
3
60.25.29
- Remove and refit
FRONT HUB WHEEL STUDS
~l
Triumph TR6 Manual. Part No. 545277 Issue 1
60.25.29