Table of Contents
Advertisement
MANIFOLD AND EXHAUST SYSTEM
INDUCTION MANIFOLD - REAR (PETROL INJECTION
MODELS) (From Engine No. CRIE)
Removing
1.
Remove the air intake manifold. 19.70.01.
2.
Remove the brake servo vacuum hose from the
manifold.
3.
Remove the clamp bolt and plate and remove the two
injectors.
4.
Ease the rubber connectors to one side on
a.
the air rail
b.
the balance pipe.
5.
Slacken the rear throttle adjusting screw clear of the
butterfly lever.
6.
Remove the three nuts, spring washers and two
clamps securing the manifold to the cylinder head.
7.
Withdraw the manifold.
. - Remove and refit
30.15.03
Refitting
8.
Refit the manifold loosely securing with the three
nuts, spring washers and clamps.
9.
Manoeuvre the manifold so that the butterfly lever is
spaced equidistant between the fork lever of the
centre manifold. Finally tighten the manifold nuts.
10.
Reverse instructions 2 to 4.
II.
Adjust the throttle butterflies. 19.20.05.
INDUCTION
MANIFOLD
-
CENTRE
(PETROL
INJECTION MODELS) (From Engine No. CRIE)
- Remove and refit
30.15.04
Removing
1.
Remove the air intake manifold. 19.70.01.
2.
Remove the clamp bolt and clamp and withdraw the
two injectors.
3.
Disconnect the cold start cable from the manifold
linkage.
4.
Disconnect the metering unit vacuum pipe from the
manifold.
5.
Ease the rubber connectors to one side on
a.
the air rail
b.
the balance pipe.
6.
Disconnect the cold start cam return spring.
7.
Slacken both throttle adjusting screws clear of the
butterfly levers.
8.
Remove the three nuts, spring washers and clamps
securing the manifold to the cylinder head.
9.
Withdraw the manifold complete with the cold start
linkage.
10.
Remove the two bolts, spring and plain washers
securing the linkage to the manifold and withdraw
the linkage.
5
~8.12
~~
)
30.15.03
30.15.04
Triumph TR6 Manual. Part No. 545277 Issue I
Hide quick links:
Advertisement
Table of Contents
