Triumph TR6 PI Operation Manual page 341

FRONT SUSPENSION
Refitting
15. Fit the inSulating rings to the road spring: thin ring to
top: thick ring to bottom.
16. Engage the top of the spring in the spring turret.
17. Engage the spring pan in the lower end of the spring.
18. Position the jack on the spring plate directly under
the spring. Ensure that the jack pad will neither slip
nor cause damage to the damper studs.
19. Carefully raise the jack and compress the road spring.
20. Align the spring plate with its location on the lower
wishbone arms and enter the studs and five securing
bolts. The bolt securing the anti· roll bar link bracket
should be omitted at this stage.
21. Fit the five plain washers and nuts and evenly draw
the spring plate into position on the wishbone arms.
22. Fit the anti- roll bar link bracket, spacer and securing
bolt, plain washer and nut. Tighten the bolt and nut.
23. Tighten the other five nuts.
24. Engage and align the trunnion in the lower wishbone
ensuring that the trunnion thrust washers are not
omitted.
25. Fit the trunnion bolt, washers and slotted nut.
26. Tighten the slotted nut and secure with a new split
pin.
27. Remove the jack from under the lower wishbone.
28. Fit the front damper 60.30.02.
29. Fit the anti· roll bar link.
30. Fit the front wheel and remove the stand(s) from the
chassis.
60.20.01 Sheet 2
Triumph TR6 Manual. Part No. 545277 Issue 1
~
~