Triumph TR6 PI Operation Manual page 196

Removing
1. Disconnect the inner and outer cables from both
carburetters.
2. Slacken the ferrule on the control panel (to facilitate
the release of the locknut).
3. Unscrew the locknut behind the control panel and
withdraw the cable complete through the locknut,
the control panel and the bulkhead.
Refitting
4. Feed the cable complete through the control panel
hole and pass the locknut over the cables.
5. Secure the outer cable assemblies to the control panel
with the locknut and ferrule so that the end of the
threaded part of the outer cable is flush with the
ferrule on the control panel.
6. Feed the carburetter ends of the cable through the
bulkhead and connect both inner and outer cables to
the carburetters.
Refitting
4. Feed the twin inner cables through the outer cables
until the control knob is fully home.
5. Secure the outer cables to the clips on both
carburetters.
6. Connect the inner cables to the carburetter trunnions.
Removing
I. Disconnect the inner cables from both carburetters.
2. Release the outer cables from the clips on the
carburetters.
3. From within the car pull the mixture control knob
out and withdraw the twin inner
~ables
complete
with the knob. - see 19.20.13.
MIXTURE CONTROL CABLE
- Remove and refit
MIXTURE CONTROL CABLE - INNER
- Remove and refit
19.20.13
19.20.14
FUEL SYSTEM - TC
NT' 389
NT2899
"
.
'i
Triumph TR6 Manual. Part No. 545217 Issue I
19.20.13C
IIJ.1U.14C