Triumph TR6 PI Operation Manual page 168

Assemble
25. Fit the brush assembly.
26. If necessary fit the circlip.
27. Position the armature to the cover against the action
of the permanent magnet.
28. Fit the thrust washer.
29. If the shaft seal is fitted only -
Provide a protective bullet as shown. Position the
protective bullet over the shaft key. Lightly grease
the bullet. Carefully insert the armature shaft through
the base casting. Align the bullet to the shaft seal.
Push each brush back to clear the thrust washer,
circlip and commutator.
30. If the shaft seal is not fitted only -
Carefully insert the armature shaft through the base
casting. Push each brush back to clear the thrust
washer, circlip and commutator.
31. Seat the cover against the base casting flange. Turn
the cover to align the marks shown. Fit the through
bolts.
32.
If the shaft seal is not fitted only -
Provide a protective bullet as
shown~
Position the
protective bullet over the shaft· key. Lightly grease
the bullet. Carefully insert the shaft seal into the base
casting.
33. Position the drive coupling to the motor.
34. Renew all disturbed rubber '0' rings. Note that
effective seals cannot be assured if new rubber '0'
rings are not fitted to the disturbed joints. Fit the
gear pump assembly. Tighten six bolts equally.
35. Insert the strainer through the inlet connection. Fit
the inlet connection and the outlet connection.
36. Adjust the armature end float as follows:
Hold the fuel pump vertical with the adjuster
uppermost. Slacken the locknut. Screw the adjuster
in until resistance is felt. Screw the adjuster out a
quarter of a turn - maintain in this position and
tighten the locknut.
31----
1
FUEL SYSTEM -PI
1---29-30
~3'
Triumph TR6 Manual. Pan No. 545277 Issue 1
19.45.15 P.I. Sheet 3