Triumph TR6 PI Operation Manual page 371

Removing
1. Remove the carpet from the rear of the transmission
tunnel to expose the handbrake lever assembly.
2. Release the handbrake.
3. Jack up the rear wheels and support the chassis on
stands.
4. Remove the clevis pins securing the cable forks to the
backplate levers.
5. Remove the nuts and spring washers securing the
brake cable supports to the trailing arms.
6. Release the brake cables from the handbrake
compensator
7. Remove the brake cables.
HANDBRAKE CABLE ASSEMBLIES - SET
- Remove and refit
70.35.16
BRAKES
Refitting
8. Fit the inner cables to the compensator and the outer
casings to the trailing arms.
9. Tighten the brake adjusters on the rear backplates
until the wheels are locked.
10. Adjust the brake cable forks equally until the clevis
pins will just enter the forks and backplate levers
without force.
II . Check that the compensator is central and if
necessary readjust cable length by means of the cable
forks.
12. Slacken the brake adjusters until the wheels rotate
without brake drag.
13. Remove the stands and jack.
14. Fit the carpet t,o the rear of the transmission tunnel.
Triumph TR6 Manual. Part No. 545277 Issue 1
70.35.16