Triumph TR6 PI Operation Manual page 408

BODY
VALANCE - AIR INTAKE
5. Reverse instructions 1 to 4.
Refitting
Refitting
76.79.04
76.81.01
- Remove and refit
WINDSCREEN
- Remove and refit
Removing
1. Disconnect the overflow pipe from the radiator filler
neck.
2. Slacken the two nuts securing the stay rods to the
wheel arches.
3. a. (Carburetter vehicles) Remove the four bolts
and washers.
b.
(p.I.
vehicles) Remove the three bolts and
washers.
c. (P.I. vehicles) remove the nut and washer
securing the air cleaner support strap.
4. Lift out the valance.
Removing
I. Remove the wiper arms 84.15.01.
2. Remove the interior mirror.
3. Remove the sun visors.
4. Break the seal, using a suitably blunt tool.
5. Push the glass outwards.
CAUTION: Take care to avoid scratching the glass, which
must be steadied by an assistant.
6. Remove the finisher moulding, clip and weatherstrip
noting positions for refitting.
7.
8.
9.
10.
II.
Assemble the weatherstrip finisher moulding and clip
to the glass, using a new weatherstrip if necessary and
applying Seelastik to the glass channel before
fitting. "
Insert a strong '''cord into the weatherstrip inner
channel, allowing the ends to protrude from the
lower edge.
Have an assistant position the glass centrally in the
frame and maintain a steady pressure whilst the cord
ends are pulled to locate the weatherstrip on the
body flange.
Seal the outer channel of the weatherstrip to the
body using Seelastik.
Reverse instructions 1 to 3.
NT 2-4-42
76.79.04
76.81.01
Triumph TR6 Manual. Pan No. 545277 Issue I
~
1 Zj