Table of Contents
Advertisement
FRONT SUSPENSION
Dismantling
2.
Remove the thrust washers.
3.
Remove the nylon bushes and backing washers.
TRUNNION
- Overhaul
I.
Remove the trunnion from the car 60.15.03.
60.15.13
Assembling
4.
Reverse instructions 2 to 3 using new components.
5.
Fit the trunnion to the car 60.15.03.
Removing
I.
Jack up the car and support the chassis on stand(s).
2.
Remove the front wheel.
3.
Remove the front damper 60.30.02.
4.
Disconnect the anti·roll bar link from the anti-roll
bar.
5.
Position a jack under the lower wishbone spring plate
ensuring that the jack pad will not damage the
damper mounting studs. Ensure also that the pad
does not obstruct the spring plate securing bolts. The
jack pad must be placed directly under the spring
lower seat.
6.
Raise the jack to partially compress the road spring
and to relieve the vertical link joints of spring tension.
7.
Remove the split pin, slotted nut, washers and bolt
securing the trunrtion to the lower end of the verical
link.
8.
Release the vertical link and trunnion from the outer
ends of the lower wishbone.
9.
Remove the nut, washer and bolt securing the
anti-roll bar link bracket to the lower wishbone.
10.
Withdraw the anti- roll bar link bracket and spacer
from the wishbone.
11.
Remove the five nuts, washers and three bolts
securing the spring plate to the lower wishbone.
12.
Separate the lower wishbone arms from the spring
plate.
13.
Carefully lower the jack taking care that the spring
plate does not foul on the chassis. Continue lowering
the jack until the road spring is relieved of tension.
14.
Withdraw the spring plate and the road spring
complete with upper and lower insulating rings.
NT2232
60.20.01
- Remove and refit
FRONT ROAD SPRING
Continued
Triumph TR6 Manual. Part No. '45217 Issue I
60.15.13
60.20.01 Sheet 1
Hide quick links:
Advertisement
Table of Contents
