Table of Contents
Advertisement
Removing
I.
Raise the car on a ramp, support the body on stands
and locate a jack under the hypoid casing.
2.
Remove exhaust tail box and rear pipe complete
30.10.19.
3.
Roll back the rubber dust shields.
4.
Disconnect the drive shafts from the inner.axle shafts
and propeller shaft from the pinion flange, four nuts
and bolts on each.
5.
Disconnect the nearside handbrake cable bracket, one
bolt to the hypoid case.
6.
Remove four nuts (two front mountings, two rear
mountings) and heavy plain washers. Remove rubbers
from front mountings only.
7.
Carefully lower the jack until the two rear mountings
are clear of the two chassis mounted studs.
8.
Carefully withdraw the hypoid casing to the rear of
the car, taking care not to damage the petrol pipes or
brake fluid pipes.
HYPOID CASING
- Remove and refit
51.25.25
REAR AXLE
Refitting
9.
Carefully reposition the hypoid casing over the
chassis studs.
10.
Refit the rubbers over the front mountings.
I I.
Refit four heavy plain washers and nuts.
12.
Connect up the nearside handbrake cable bracket to
the hypoid housing.
13.
Connect up the drive shafts to the inner axle shafts
and the propeller shaft, four nuts and bolts on each.
14.
Reposition the rubber dust shields over the universal
joints.
15.
Refit the exhaust tail box and rear pipes complete
30.10.19.
16.
Remove the stands and lower the ramp.
Triumph TR6 Manual. Part Nc>. 545277 Issue I
51.25.25
Hide quick links:
Advertisement
Table of Contents
