Triumph TR6 PI Operation Manual page 506

ELECTRICAL
SWITCHES
Ignition/starter switch - remove and refit 86.65.02
Removing
Early vehicles with ignition/starter switch fitted to central
control cowl.
Refitting
5. Reverse instructions I to 4. Connect five Lucar
connectors as shown on fascia connections 88.00.02.
Isolate) the battery.
RemQ'ire single screw and washer and withdraw the
ge~ox
cover side trim panel on the right hand side
of the vehicle.
Disconnect five Lucar connectors.
Unscrew the bezel. Withdraw the switch from the
control cowl.
1.
2.
3.
4.
SWITCHES
Ignition/starter switch - remove and refit 86.65.02
Later vehicles with ignition/starter switch fitted to steering
column lock assembly.
Removing
1. Isolate the battery.
2. Carefully pull the plastic cover from the steering
column lock assembly and manoeuvre along the
harness.
3. Withdraw the ignition/starter switch from the steering
column lock assembly.
4. Disconnect five Lucar connectors.
NT0728
Refitting
5. Ensure that the plastic cover is fitted onto the
harness.
6. Connect five Lucar connectors as shown.
7. Insert the switch into the steering column lock
assembly. Note the keyway and ensure that the lock
shaft and switch shaft align correctly.
8. Carefully fit the plastic cover to secure the switch in
position.
9. Connect the battery.
W White wire
NW Brown/white wire
WR White/red wire
AUX Any auxiliary wire
rI ~
~
Triumph TR6 Manual. Pan No. 545277 Issue J
LaVL.....D
86.65.02