Triumph TR6 PI Operation Manual page 474

LAMPS
- Front parking and flasher lamp -
remove and refit
86.40.26
ELECTRICAL
Removing
I. Remove two screws and withdraw the lens.
2. Remove the bulb/bulbs (according to market) from
the bayonet fitting/fittings.
3. Remove the air intake valance 76.79.04.
4. Locate the appropriate harness break out and
disconnect three snap connectors.
5. Remove two nuts, spring washers and washers.
6. Withdraw the lamp assembly from the panel.
Refitting
7. Reverse instructions I to 6. Note that the lamp green
wire should be connected to the harness green/red
wire for the left hand lamp and to the harness
green/white wire for the right hand lamp.
LAMPS
Removing
1. Remove two screws and withdraw the lens.
2. Remove the bulb from the bayonet fitting.
3. Remove the air intake valance 76.79.04.
4. Locate the appropriate harness break out and
disconnect two snap connectors.
5. Remove two nuts and washers.
6. Withdraw the lamp assembly from the panel.
- Front marker lamp - remove and refit
86.40.59
Refitting
7. Reverse instructions I to 6.
Triumph TR6 Manual. Part No. 545277 Issue 1
86.40.26
86.40.59