Triumph TR6 PI Operation Manual page 208

OVERFLOW PIPE
- Remove and refit
26.30.31
COOLING SYSTEM
Removing
l. Detach the overflow pipe from the radiator.
2. Withdraw the overflow pipe from the filler cap of the
overflow bottle.
Refitting
3. Reverse instructions 1 and 2. Ensure that the bottle
end of the tube reaches to approximately 3/8 in (9'5
rnrn) of the bottom of the bottle.
RADIATOR
- Remove and refit 26.40.01
Removing
1. Drain the cooling system.
2. Disconnect the top hose at the radiator.
3. Slacken the two bolts and nuts securing the lower end
of the radiator stays to the tubular cross member.
4. Remove the two nuts and spring washers securing the
upper end of the radiator stays to the radiator.
5. Detach the stays from the radiator.
6. Remove the two bolts and washers (earlier cars) or
two nuts and washers (later cars) securing the radiator
to the car.
**
7. Withdraw the radiator and the two packing pieces.
Refitting
8. Locate the radiator in position on the car and fit the
two packing pieces below the radiator mounting
brackets. Fit the two mounting bolts and washers.
9. Reverse instructions 1 to S.
3
5
Triumph TR6 Manual. Part No. 545277 Issue 2
26.30.31
26.40.01