Triumph TR6 PI Operation Manual page 400

BODY
FASCIA - VENEERED
- Remove and refit 76.46.01
Removing
1. Isolate the battery.
2. Remove the speedometer 88.30.01.
3. Remove the tachometer 88.30.21.
4. Remove the two screws securing the glovebox lid to
the check link.
5. Remove the five screws and cup washers securing the
veneered fascia to the metal fascia.
6. Carefully lower the fascia to the service position to
obtain access to the rear.
7. Pull off the rheostat knob.
8. Remove the windscreen wiper switch 86.65.38.
9. Remove the windscreen washer switch 86.65.40.
10. Remove the hazard warning light switch (if fitted)
86.65.50.
11. Pull out the hazard warning light indicator bulb
holder (if fitted).
12.
Pullout the brake line failure indicator bulb holder
(if fitted).
13. Unscrew the nut securing the pipe to the oil gauge
and pull out the bulb holder.
14. Disconnect the two Lucar connectors from the
temperature gauge and pull out the bulb holder.
15. Disconnect the two Lucar connectors from the fuel
gauge and pull out the bulb holder.
16. Pull out the bulb holder from the seat belt warning
light (if fitted).
17. Disconnect the two Lucar connectors from the
rheostat.
18. Disconnect the two Lucar connectors from the
ammeter and pull out the bulb holder.
19.
Remove the fascia from the car.
Refitting
20. Reverse instructions I to 19. Refer to Fascia
Connections 86.00.01, to ensure correct reconnection
of Lucar connectors.
Refitting
6. Apply 8758 adhesive to mating surfaces of the crash
pad and the bulkhead panel.
7. Reverse instructions 1 to 5.
Removing
1. Remove the veneered fascia 76.46.01.
2. Remove the five nuts and washers securing the metal
fascia to the crash pad.
3. Remove the two demister ducts 80.15.03.
4. Remove the windscreen frame 76.81.02.
5. Remove the crash pad.
FASCIA CRASH PAD - UPPER
- Remove and refit 76.46.04
76.46.01
76.46.04
Triumph TR6 Manual. Part No. 545277 Issue
J