Triumph TR6 PI Operation Manual page 342

Removing
1. Jack up the car and remove the front wheel.
2. Wire wheels only. Remove the four nuts securing the
hub extension to thehuL. Withdraw the hub
extension.
Remove the two bolts and spring washers
Sf
'uring the
caliper to the vertical link and ease the caliper clear of
the disc. Support the caliper using string or wire.
Ensure that strain is not imposed on the flexible
brake hose.
4. Remove the hub cap.
5. Remove the split pin, slotted nut and washer securing
the hub to the stub shaft.
6. Withdraw the hub complete with bearings, inner hub
seal and disc.
FRONT HUB
- Remove and refit
60.25.01
FRONT SUSPENSION
Refitting
7. Partially pack the hub with clean grease.
8. Ensure that the hub seal is installed on the inner side
of the hub and fit the hub and bearings to the stub
shaft.
9. Fit the washer and slotted nut to the stub shaft.
10. Tighten the slotted nut to 5 Ibf ft (0·7 kgf m) and
slacken the nut one flat to allow insertion of a new
split pin. The required end-float is 0.003 to 0.005 ins
(0-08 to 0·13 mm).
11. Fit the split pin.
12. Half fill the hub cap with clean grease and fit the cap
to the hub.
13. Remove the string or wire supporting the caliper and
fit the caliper. Note that the caliper upper bolt also
secures the disc shield and the flexible hose support
bracket.
14. Wire wheels only. Fit the hub extension.
15. Fit the road wheel and remove the jack.
Triumph TR6 Manual. Part No. 545277 Issue 1
I
I
l',-L_
6
NT251b
60.25.01