Triumph TR6 PI Operation Manual page 305

Removing
l. For right hand inner axle shaft, remove exhaust tail
box and rear pipes 30.10.19.
2. Disconnect inner drive shaft from flange.
3. Remove four bolts and spring washers securing inner
shaft oil seal housing to hypoid casing.
4. Withdraw inner shaft complete with driving flange, oil
seal housing and ball race.
5. Remove nyloc nut and plain washer from shaft.
6. Withdraw driving flange, key and oil seal.
7. Remove ball race from shaft.
8. Extract oil seal from housing.
Refitting
9. Fit ballrace to shaft until outer face of ball race is
approximately aligned with end of shaft taper.
10. Lay oil seal housing flat on bench with the smaller
diameter uppermost. Insert oil seal (lip leading) into
the housing until the plain face of the seal is flush
with the housing.
11. Lubricate lip and slide seal over driving flange (plain
face of seal leading). Ensure driving flange deflector
seal is undamaged and will not foul the oil seal
housing.
12. Fit key, driving flange and oil seal housing to the
shaft.
13. Fit the plain washer and the nyloc nut to the shaft.
Tighten the nut.
14. Enter the shaft into the hypoid casing engaging the
splines in the sungear.
IS. Fit and tighten th,e four spring washers and bolts
securing the oil seal housing to the hypoid casing.
16. Connect up the drive shaft to the inner shaft.
17. For the right hand inner shaft, refit the tail box and
rear pipes 30.10.19.
18. Top up the differential unit with oil.
INNER SHAFT BEARING AND OIL SEAL
- Remove and refit
51.10.02
REAR AXLE
J
~ . ~ . ' _ · V L ' T " - - ' · N H D
~
Triumph TR6 Manual. Part No. 545277 Issue I
51.10.02