Table of Contents
Advertisement
ELECTRICAL
SWITCHES
- Hazard switch - remove and refit
Left hand steer vehicles only.
86.65.50
Removing
1.
Isolate the battery.
2.
To gain access remove either the speedometer
88.30.01 or the tachometer 88.30.21. The choice
depends entirely on which operation is preferred by
the individual fitter.
3.
Push inwards two plastic clips on the switch and
withdraw the switch from the panel.
4.
Disconnect the Lucar connectors.
Refitting
5.
Early left hand steer vehicles with hazard circuit using
relay -
Connect the Lucar connectors as shown on fascia
connections 88.00.02.
6.
Later left hand steer vehicles with hazard circuit not
using relay -
Connect the Lucar connectors as shown on fascia
connections 88.00.04.
7.
Reverse instructions 1 to 3.
SWITCHES
NTOB23
Removing
1.
Locate the switch adjacent to the brake pedal arm.
2.
Disconnect two Lucar connectors.
3.
Slacken the large hexagon nut.
4.
Unscrew the switch from the nut.
5.
Collect up the nut and two shakeproof washers.
Refitting
6.
Assemble the switch, two shakeproof washers and the
nut to the bracket. A shakeproof washer should be
positioned either side of the bracket. Do not
overtighten the nut on the plastic threads or the
switch may be damaged.
7.
Connect two Lucar connectors either way round.
8.
Switch on the ignition and perform a functional
check of the stop lamp circuit.
- Stop lamp switch - remove and refit
86.65.51
NTonl
86.65.50
86.65.51
Triumph TR6 Manual. Part No. 545277 Issue I
~
~
Hide quick links:
Advertisement
Table of Contents
