Triumph TR6 PI Operation Manual page 518

SWITCHES
Heat:r switch - remove and refit
86.65.44
ELECTRICAL
Removing
1. Insert a suitable probe into the hole in the knob and
depress the spring plunger while pulling the knob
from the shaft.
2.
Remove single screw and washer and withdraw the
gearbox cover side trim panel on the passenger side of
the vehicle.
3. Disconnect three Lucar connectors.
4. Unscrew the bezel. Withdraw the switch from the
control cowl.
Refitting
5.
Reverse instructions I to
4.
Connect three Lucar
connectors as shown on fascia connections 88.00.02
or 88.00.04.
SWITCHES
- Brake line failure switch
-;- remove and refit
Left hand steer vehicles only.
86.65.47
Removing
I.
Open the bonnet.
2.
Locate the pressure differential warning actuator
mounted on the left hand front wheelarch to
bulkhead panel.
3. Pull the harness plug from the switch.
4. Using a spanner on the nylon switch body carefully
unscrew the switch.
Refitting
5. Carefully screw the switch to the actuator body.
Do
not overtighten. Torque load to only 12 to 15 in Ibf
(0'14 to 0·17 kgf m).
6. Fit the harness plug to the switch. Ensure that the
plug claws are correctly located. Note that the single
wire, but twin socket, harness plug may be fitted
either way round as the twin switch pins are
electrically common.
Triumph TR6 Manual. Part No.
54S277
Issue I
86.65.44
86.65.47