Vrrp Delay Minimum; Vrrp Delay Reload - Dell Force10 Z9000 Reference Manual

Usage
The VRRP group only becomes active and sends VRRP packets when a virtual IP address is
Information
configured. When you delete the virtual address, the VRRP group stops sending VRRP packets.
A system message appears after you enter or delete the virtual-address command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual
address with the same IP address as the interface's primary IP address and change the priority
of the VRRP group to 255.
You can ping the virtual addresses configured in all VRRP groups.

vrrp delay minimum

Set the delay time for VRRP initialization after an interface comes up.
Z-Series, S4810
Syntax vrrp delay minimum seconds
Parameters
seconds
Defaults 0
Command Modes INTERFACE
Command History
Version 9.0.0.0
Version 8.3.8.0
Usage
This command applies to a single interface. When used in conjunction with the vrrp delay
Information
reload CLI, the later timer rules the VRRP enabling. For example, if vrrp delay reload
is 600 and the vrrp delay minimum is 300:
Related

vrrp delay reload

Command
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Z-Series, S4810
Syntax vrrp delay reload seconds
Parameters
seconds
1482
Enter the number of seconds for the delay for VRRP initialization after
an interface becomes operational. The range is 0 to 900 (0 indicates
no delay).
Introduced on the Z9000.
Introduced on the S4810.
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all
interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface.
– sets the delay time for VRRP initialization after a system reboot.
Enter the number of seconds for the delay. The range is 0 to 900 (0
indicates no delay).