Output-Delay - Dell Z9500 Command Reference Manual

Version
8.3.7.0
7.8.1.0
7.6.1.0
pre- 6.2.1.1
Usage When the offset metric is applied to an interface, that value takes precedence over
Information an offset value that is not extended to an interface.
Related ip prefix-list
Commands

output-delay

Set the interpacket delay of successive packets to the same neighbor.
Z9500
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no
output-delay command.
Parameters
delay
Defaults Not configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
Routing Information Protocol (RIP)
Description
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enters PREFIX-LIST mode and configure a prefix list.
Specify a number of milliseconds as the delay interval. The
range is from 8 to 50.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
1549