Ip Multicast Static-Neighbor - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IP Multicast Switching Commands

ip multicast static-neighbor

Creates a static IGMP neighbor entry on a specified port on a specified VLAN.
ip multicast static-neighbor vlan vid port slot/port
no ip multicast static-neighbor vlan vid port slot/port
Syntax Definitions
vid
slot/port
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove an IGMP static neighbor entry on a specified port on a
specified VLAN.
•
The ip multicast static-neighbor command allows you to create an IGMP static neighbor entry on a
specified port on a specified VLAN. This, in turn, enables that network segment to receive all the
IGMP traffic.
•
You can also create an IGMP static neighbor entry on a link aggregate port by entering
ip multicast static-neighbor vlan vid port, followed by the link aggregation group number
(e.g., ip multicast static-neighbor vlan 2 port 7).
Examples
-> ip multicast static-neighbor vlan 4 port 1/1
-> no ip multicast static-neighbor vlan 4 port 1/1
-> ip multicast static-neighbor vlan 4 port 7
-> no ip multicast static-neighbor vlan 4 port 7
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
VLAN to include as a static IGMP neighbor.
The slot/port number you want to configure as a static IGMP neighbor.
November 2009 page 41-9