Configure Stpd Add Vlan - Extreme Networks ExtremeWare XOS Command Reference Manual

Version 11.0

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

configure stpd add vlan

configure stpd <stpd_name> add vlan <vlan_name> ports [all | <port_list>]

{[dot1d | emistp | pvst-plus]}

Adds all ports or a list of ports within a VLAN to a specified STPD.

Syntax Description

All ports are in

Usage Guidelines

To create an STP domain, use the

This command adds a list of ports within a VLAN to a specified STPD provided the carrier VLAN

already exists on the same set of ports. You can also specify the encapsulation mode for those ports.

If you see an error similar to the following:

Error: Cannot add VLAN default port 3:5 to STP domain

You might be attempting to add:

• Another 802.1D mode STP port to a physical port that already contains an 802.1D mode STP port

(only one 802.1D encapsulation STP port can be configured on a particular STP port)

• A carrier VLAN port to a different STP domain than the carrier VLAN belongs

• A VLAN/port for which the carrier VLAN does not yet belong

This restriction is only enforced in an active STP domain and when you enable STP to make sure

you have a legal STP configuration.

If your STPD has the same name as another component, for example a VLAN, Extreme Networks

recommends that you specify the identifying keyword as well as the name. If your STPD has a name

unique only to that STPD, the keywords

ExtremeWare XOS 11.0 Command Reference Guide

Specifies an STPD name on the switch.

Specifies a VLAN name.

Specifies all of the ports to be included in the STPD.

Specifies the port or ports to be included in the STPD.

Specifies the STP encapsulation mode of operation to be 802.1D.

Specifies the STP encapsulation mode of operation to be EMISTP.

Specifies the STP encapsulation mode of operation to be PVST+.

mode, except those in STPD s0, whose default setting is

command. To create a VLAN, use the

are optional.

configure stpd add vlan

Extremeware xos 11.0