Disable Log Target - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Status Monitoring and Statistics

disable log target

disable log target [console | memory-buffer | nvram | primary-msm |
backup-msm | session | syslog [all | <ipaddress> ] {vr <vr_name> [local0
... local7]]]
Description
Stops sending log messages to the specified target.
Syntax Description
console
memory-buffer
nvram
primary-msm
backup-msm
session
syslog
all
ipaddress
vr_name
local0 ... local7
Default
Enabled, for memory buffer, NVRAM, primary MSM, and backup MSM; all other targets are disabled
by default.
Usage Guidelines
This command stops sending messages to the specified target. By default, the memory buffer, NVRAM,
primary MSM, and backup MSM targets are enabled. Other targets must be enabled before messages
are sent to those targets.
Configuration changes to the
telnet session, and are not saved in FLASH. Changes to the other targets are saved to FLASH.
Note that the
backup-msm
active on the backup MSM.
Example
The following command disables log messages to the current session:
disable log target session
346
Specifies the console display.
Specifies the switch memory buffer.
Specifies the switch NVRAM.
Specifies the primary MSM.
Specifies the backup MSM.
Specifies the current session (including console display).
Specifies a syslog target.
Specifies all of the remote syslog servers.
Specifies the syslog host name or IP address.
Specifies the virtual router that can reach the server IP address.
Specifies the local syslog facility.
target are in effect only for the duration of the console display or
session
target is only active on the primary MSM, and the target is only
primary-msm
ExtremeWare XOS 11.0 Command Reference Guide