IP Multicast Commands
configure pim spt-threshold
configure pim spt-threshold <leaf-threshold> {<rp_threshold>}
Description
Configures the threshold, in kbps, for switching to SPT. On leaf routers, this setting is based on data
packets. On the RP, this setting is based on register packets.
Syntax Description
leaf-threshold
rp_threshold
Default
The default setting is 0 for both parameters.
Usage Guidelines
For the best performance, use default value of 0.
Example
The following command sets the threshold for switching to SPT:
configure pim spt-threshold 4 16
History
This command was available in ExtremeWare XOS 10.1.
902
Specifies the rate of traffic in kbps for the last hop. Range is 0 - 419403.
Specifies an RP threshold. Range is 0 - 419403.
ExtremeWare XOS 11.0 Command Reference Guide