QoS Commands
configure qosprofile ports
configure qosprofile <qosprofile> [minbw <min_number> | maxbw <max_number>
| committed-rate <bps> [k | m] | peak-rate <bps> [k | m] | priority <level>
ports [<port_list> | all]
Description
Modifies the default QoS profile parameters.
Syntax Description
qosprofile
minbw <min_number>
maxbw <max_number>
committed-rate <bps> [k | m]
peak-rate <bps> [k | m]
priority <level>
port_list
all
Default
• Minimum bandwidth—0%
• Maximum bandwidth—100%
• Priority—By default, each qosprofile is assigned a different priority level:
— QP1 - 1, Low (the lowest priority)
— QP2 - 2, LowHi
— QP3 - 3, Normal
— QP4 - 4, NormalHi
— QP5 - 5, Medium
— QP6 - 6, MediumHi
290
Specifies a QoS profile name. Range is Qp1 to Qp8; the default is Qp1.
Specifies a minimum bandwidth percentage for this queue. The default setting
is 0.
Specifies the maximum bandwidth percentage this queue is permitted to use.
The default setting is 100.
Specifies an absolute number in K bits or M bits that is guaranteed for this
queue.
Specifies an absolute number in K bits or M bits that is the maximum for this
queue.
Specifies a service priority setting. Settings are:
• 1, or Low
• 2, or LowHi
• 3, or Normal
• 4 or NormalHi
• 5, or Medium
• 6, or MediumHi
• 8, or HighHi
This is the setting for the egress mode.
Specifies a list of slots and ports to which the parameters apply. May be in the
form 3-5, 2:5, 2:6-2:8.
Specifies this applies to all ports on the device.
ExtremeWare XOS 11.0 Command Reference Guide