Configure Igmp Snooping Leave-Timeout - Extreme Networks ExtremeWare XOS Command Reference Manual

configure igmp snooping leave-timeout

configure igmp snooping leave-timeout
configure igmp snooping leave-timeout <leave_timeout_ms>
Description
Configures the IGMP snooping leave timeout.
Syntax Description
leave_timeout_ms Specifies an IGMP leave timeout value in milliseconds.
Default
1000 ms.
Usage Guidelines
The range is 0 - 10000 ms (10 seconds). For timeout values of one second or less, you must set the
leave-timeout to a multiple of 100 ms. For values of more than one second, you must set the
leave-timeout to a multiple of 1000 ms (one second).
The specified time is the maximum leave timeout value. The switch could leave sooner if an IGMP
leave message is received before the timeout occurs.
Example
The following command configures the IGMP snooping leave timeout:
configure igmp snooping leave-timeout 10000
History
This command was available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide 891