Enable Ssh2 - Extreme Networks ExtremeWare XOS Command Reference Manual

enable ssh2

enable ssh2 {port <tcp_port_number>} {vr [<vr_name> | all | default]}
Description
Enables SSH2 server to accept incoming sessions from SSH2 clients.
Syntax Description
port
vr_name
all
default
Default
The SSH2 feature is disabled by default.
Usage Guidelines
SSH2 enables the encryption of session data. You must be logged in as an administrator to enable SSH2.
SSH2 functionality is not present in the base ExtremeWare XOS software image, but is in an additional,
installable module. Before you can access any SSH2 commands, you must install the module. Without
the module, the commands do not appear on the command line. To install the module, see the
instructions in Appendix A, "Software Upgrade and Boot Options".
After you have installed the SSH2 module, you must generate a host key and enable SSH2. To generate
an SSH2 host key, use the
command.
Use the
port
To view the status of SSH2 sessions on the switch, use the
management
SSH2 sessions and whether a valid key is present.
Example
The following command enables the SSH2 feature:
enable ssh2
History
This command was first available in the ExtremeWare XOS 11.0 SSH module.
ExtremeWare XOS 11.0 Command Reference Guide
Specifies a TCP port number. The default is port 22.
Specifies a virtual router name.
Specifies that SSH is enabled on all virtual routers.
Specifies that SSH is enabled on the default virtual router.
configure ssh2 key
option to specify a TCP port number other than the default port of 22.
command displays information about the switch including the enable/disable state for
command. To enable SSH2, use the
show management
enable ssh2
enable ssh2
command. The
show
445