Extreme Networks ExtremeWare XOS Command Reference Manual page 422

Security Commands
To view the status of SSH2 sessions on the switch, use the command. The show
show management
management command displays information about the switch including the enable/disable state for
SSH2 sessions and whether a valid key is present.
Example
The following command generates an authentication key for the SSH2 session:
configure ssh2 key
The command responds with the following messages:
WARNING: Generating new server host key
This will take approximately 10 minutes and cannot be canceled.
Continue? (y/n)
If you respond yes, the command begins the process.
To configure an SSH2 session using a previously generated key, use the following command:
configure ssh2 key pregenerated
The command responds with the following message:
Please enter the server key
Enter the previously-generated key (you can copy and paste it from the saved configuration file).
History
This command was first available in the ExtremeWare XOS 11.0 SSH module.
422 ExtremeWare XOS 11.0 Command Reference Guide