Enable Bgp Peer-Group Capability - Extreme Networks ExtremeWare XOS Command Reference Manual

enable bgp peer-group capability

enable bgp peer-group <peer-group-name> capability [ipv4-unicast |
ipv4-multicast | route-refresh]
Description
This command enables BGP Multiprotocol (MP) and route-refresh capabilities for a peer-group.
Syntax Description
peer-group-name
ipv4-unicast
ipv4-multicast
route-refresh
Default
All capabilities are disabled by default.
Usage Guidelines
This command enables BGP Multiprotocol and route-refresh capabilities for a peer group. After the
capabilities have been enabled, the BGP peer will announce its capabilities to neighbors in an OPEN
message.
Example
The following command enables the route-refresh feature for the peer group outer:
enable bgp peer-group outer capability route-refresh
History
This command was available in ExtremeWare XOS 10.1.
ExtremeWare XOS 11.0 Command Reference Guide
Specifies a peer group.
Specifies BGP MP unicast capabilities.
Specifies BGP MP multicast capabilities.
Specifies ROUTE-REFRESH message capabilities.
enable bgp peer-group capability
863