Configure Ospf Add Vlan Area Link-Type - Extreme Networks ExtremeWare XOS Command Reference Manual

IGP Commands

configure ospf add vlan area link-type

configure ospf add vlan <vlan-name> area <area-identifier> link-type [auto
| broadcast | point-to-point] {passive}
Description
Configures the OSPF link type.
Syntax Description
vlan-name
area-identifier
auto
broadcast
point-to-point
passive
Default
Auto.
Usage Guidelines
The passive parameter indicates that the router only synchronizes and listens, and does not originate or
send any new information on the interface.
Example
The following command configures the OSPF link type as automatic on a VLAN named accounting:
configure ospf add vlan accounting area 0.0.0.1 link-type auto
History
This command was available in ExtremeWare XOS 10.1.
692
Specifies a VLAN name.
Specifies the area to which the VLAN is assigned.
Specifies to automatically determine the OSPF link type based on the
interface type.
Specifies a broadcast link, such as Ethernet. Routers must elect a DR and a
BDR during synchronization.
Specifies a point-to-point link type, such as PPP.
Specifies to stop sending and receiving packets on this interface.
ExtremeWare XOS 11.0 Command Reference Guide