Configure Stpd Priority - Extreme Networks ExtremeWare XOS Command Reference Manual

STP Commands

configure stpd priority

configure stpd <stpd_name> priority <priority>
Description
Specifies the bridge priority of the STPD.
Syntax Description
stpd_name
priority
Default
The default priority is 32,768.
Usage Guidelines
If your STPD has the same name as another component, for example a VLAN, Extreme Networks
recommends that you specify the identifying keyword as well as the name. If your STPD has a name
unique only to that STPD, the keyword
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
By changing the priority of the STPD, you can make it more or less likely to become the root bridge.
The range for the
<priority>
priority.
Example
The following command sets the bridge priority of STPD1 to 16,384:
configure stpd stpd1 priority 16384
History
This command was available in ExtremeWare XOS 10.1.
512
Specifies an STPD name on the switch.
Specifies the bridge priority of the STPD. The range is 0 through 65,535.
is optional.
stpd
parameter is 0 through 65,535. A setting of 0 indicates the highest
ExtremeWare XOS 11.0 Command Reference Guide