Configure Vman Add Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

Version 11.0

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

configure vman add ports

configure vman <vlan_name> add ports [ all | <port_list> ] {untagged |

tagged | nobroadcast }

Adds one or more ports in a VMAN.

Syntax Description

Usage Guidelines

If you do not specify a parameter, the default value is untagged. If you specify the parameter

have specified tagged packets.

The VMAN tunnel begins at the ingress, or customer access, port and terminates at the egress, or trunk,

port. Traffic flows from the egress trunk port onto the network thereafter without the VMAN tag.

Ensure that all the switch-to-switch ports in the VMAN tunnel are configured as tagged ports.

Configure the VMAN ingress, or customer access, port as an untagged port (although this port does

accept tagged packets). You must configure the VMAN tunnel egress, or trunk, port as an untagged port

so that the VMAN header is stripped from the frame.

You must configure the VMAN tunnel egress, or trunk, port as untagged so that the VMAN header is

stripped from the frame.

The VMAN must already exists before you can add (or delete) ports: use the

create the VLAN.

All VMAN ports are automatically enabled for jumbo frames to accommodate the extra VMAN tag. The

Extreme Networks default Ethernet type for VMAN is 088a8.

All ports added to a specified VMAN must be in the same virtual router. For more information on

displaying, configuring, and using virtual routers, see Chapter 6.

ExtremeWare XOS 11.0 Command Reference Guide

Specifies a VMAN name.

Specifies all ports.

Specifies a list of slots and ports. May be in the form 3-5, 2:5, 2:6-2:8.

Specifies that the ports are untagged.

Specifies that the ports are tagged.

Specifies that the ports do not forward broadcast, multicast, or unknown

unicast packets.

, the system used the default value of untagged; you cannot add

configure vman add ports

Extremeware xos 11.0