Configure Dot1P Type - Extreme Networks ExtremeWare XOS Command Reference Manual

QoS Commands

configure dot1p type

configure dot1p type <dot1p_priority> [qosprofile <qosprofile>]
Description
Configures the default QoS profile to 802.1p priority mapping.
Syntax Description
dot1p_priority
qosprofile
Default
The default mapping of each 802.1p priority value to QoS profile is as follows:
Dot1p Priority QoS Profile
0 QP1
1 QP2
2 QP3
3 QP4
4 QP5
5 QP6
6 QP7
7 QP8
Usage Guidelines
An 802.1p priority value seen on ingress can be mapped to a particular QoS profile and with specific
bandwidth management and priority behavior.
Example
The following commands swap the QoS profiles associated with 802.1p priority values 1 and 2:
configure dot1p type 2 qosprofile qp2
configure dot1p type 1 qosprofile qp3
History
This command was first available in ExtremeWare XOS 11.0.
286
Specifies the 802.1p priority value. The value is an integer between 0 and 7.
Specifies a specific QoS profile.
ExtremeWare XOS 11.0 Command Reference Guide