Show Log Counters - Extreme Networks ExtremeWare XOS Command Reference Manual

show log counters

show log counters {<event condition> | [all | <event component>]} {include
| notified | occurred} {severity <severity> {only}}}
Description
Displays the incident counters for events.
Syntax Description
event condition
all
event component
include
notified
occurred
severity
only
Default
If
severity
Usage Guidelines
This command displays the incident counters for each event specified. Two incident counters are
displayed. One counter displays the number of times an event has occurred, and the other displays the
number of times that notification for the event was made to the system (an incident record was injected
into the system for further processing). Both incident counters reflect totals accumulated since reboot or
since the counters were cleared using the
regardless of whether it was filtered or not.
The keywords
the corresponding counter.
This command also displays a reference count (the column titled
is the number of enabled targets receiving notifications of this event.
See the command
To get a listing of the event conditions in the system, use the following command:
show log events
To get a listing of the components present in the system, use the following command:
show log components
ExtremeWare XOS 11.0 Command Reference Guide
Specifies the event condition to display.
Specifies that all events are to be displayed.
Specifies that all the events associated with a particular component or
subcomponent should be displayed.
Specifies the number of targets that use filters that include this event.
Specifies the number of times this event has occurred.
Specifies the number of times this event has occurred since the last clear or
reboot.
Specifies the minimum severity level of events to display (if the keyword only
is omitted).
Specifies that only events of the specified severity level are to be displayed
is not specified, then events of all severity are displayed.
, , and
include notified
on page 364 for more information about severity levels.
show log
clear log counters
only display events with non-zero counter values for
occurred
or command,
clear counters
in the output). The reference count
Rf
show log counters
377