Clear Log - Extreme Networks ExtremeWare XOS Command Reference Manual

Commands for Status Monitoring and Statistics

clear log

clear log {error-led | static | messages [memory-buffer | nvram]}
Description
Clears the log database.
Syntax Description
error-led
static
memory-buffer
nvram
Default
N/A.
Usage Guidelines
The switch log tracks configuration and fault information pertaining to the device.
By default, log entries that are sent to the NVRAM remain in the log after a switch reboot. The
and
log clear log messages memory-buffer
the
clear log static
NVRAM target. In addition, the
There are three ways to clear the ERR LED. Clear the log, reboot the switch, or use the
command. To clear the ERR LED without rebooting the switch or clearing the log messages,
error-led
use the
clear log error-led
Example
The following command clears all log messages, from the NVRAM:
clear log static
History
This command was first available in ExtremeWare XOS 10.1.
312
Clears the ERR LED on the MSM.
Specifies that the messages in the NVRAM and memory-buffer targets are
cleared, and the ERR LED on the MSM is cleared.
Clears entries from the memory buffer.
Clears entries from NVRAM.
and
clear log messages nvram
clear log static
command.
commands remove entries in the memory buffer target;
commands remove messages from the
command will also clear the memory buffer target.
clear
clear log
ExtremeWare XOS 11.0 Command Reference Guide